Table of Contents
Advertisement
RCal I/O
RF Output
The RF Output connector on the RCal module is the physical point where the calibration data
applies.
An adapter may be needed between the RCal output and test port where calibration is desired. Use
the shortest and highest quality connectors possible. Mismatch errors can be reduced with small
fixed attenuators, such as a 6 dB attenuator.
Higher frequencies require smaller connector geometries, such as 1 mm. To avoid damaging these
fragile connectors, please follow the recommendations in
"Appendix: Connector Care" on page
61.
6
U9361C/F/G/M RCal Receiver Calibrator Measurement Guide
Advertisement
Table of Contents
