Demonstrations - Keysight Technologies U9361C Measurement Manual

Demonstrations

Demonstrations
Demo Setup
The following diagram shows the configuration for all front-panel demonstrations.
These demonstrations show how to correct for absolute power accuracy under the Swept SA
application.
— Some demos involve the use of fixed attenuators, which should be inserted into the RF path
such that the attenuator is present in both the signal generator to signal analyzer path as well as
the RCal to signal analyzer path.
— The switch in the diagram represents changing the physical connection to the signal analyzer to
use either the signal generator or RCal as the RF input.
— The Trig connections between the signal generator and signal analyzer are recommended for
demos involving source control. The software trigger can also be used without a physical
connection.
— The USB-C connection is located above the Ext Ref In and Trig Out ports, as shown below.
20 U9361C/F/G/M RCal Receiver Calibrator Measurement Guide