Demonstrations
7. Connect the RF output of the signal generator to the RF Input of the signal analyzer.
8. Select Meas Setup > Source > RF Output > On to enable the RF output of the signal generator.
9. Select Trace > Select Trace > Trace 1, set Trace Type > Max Hold, and set View > Active.
10.Once the trace has stabilized, save it for comparison by setting View > View.
11.Disable the RF output on the signal generator from Meas Setup > Source > RF Output > Off.
12.Disconnect the cable from the signal generator and connect it to the RCal module.
30
U9361C/F/G/M RCal Receiver Calibrator Measurement Guide