Demo #4 - Using Rcal With The 89600 Vsa Software - Keysight Technologies U9361C Measurement Manual

Demo #4 - Using RCal with the 89600 VSA Software

Compatible Signal Generators:
— N5166B (CXG)
— N517xB (all EXG)
— N518xB (all MXG)
— N519xA (all UXG)
— M9x84B/C (all VXG)
RCal calibrations are supported by 89600 VSA software but must be set up outside of the VSA
application. Before beginning the following demo, complete
EVM in a 128 QAM Signal" on page 36
1. Start the VSA application.
Mode/Measure > Launch VSA
2. Configure the Trace Layout to be a 2x2 grid.
Window > Trace Layout > Grid 2x2
3. Set the Measurement Type to Digital Demod.
U9361C/F/G/M RCal Receiver Calibrator Measurement Guide
"Demo #3 – Complex Cal: Improving
Demo #3 for RCal calibration setup for the uW path.
Demonstrations
43