Table of Contents
Advertisement
U3022AH10
System Setup, 12/14 Port RF Cable Interface Configuration
Figure 12
and
Figure 13 on page 26
Multiport Test Set and how it should be configured to the N5242A/B Option 200 (2-Port) or 400
(4-Port) PNA-X Network Analyzer.
1. Remove the four front panel jumpers on the PNA-X (Ports 1 & 2) from the SOURCE and RCVR
ports. The Reference jumpers must remain installed.
2. If not already installed, connect the 16 front panel jumpers (N5222-20091), as shown in
Figure 12
on
page
26.
3. Connect the RF cables from the N5242A/B Network Analyzer to the Test Set. Torque each
cable to 8 in-lb. Refer to
Each end of the interconnect RF cables have a different length from the bend.
When connecting the RF Interconnect cables ensure that the longer end from the
bend is connected to the PNA-X.
Over-torque will cause damage to the Test Set and may cause connectors to
spin or become loose.
4. Add the front panel port labels to the N5242A/B Option 400 (4-Port). Refer to
• Port 13 over Port 3 (U3022-80002)
• Port 14 over Port 4 (U3022-80003)
5. Connect the cable (N4011-21002) from the PNA-X Test Set I/O to the U3022AH10 Test Set I/O on
the rear panel. See
6. The 2-digit numbers in
digits) listed in
Table
note that it might be necessary to reform the semi-rigid cable slightly to fit in place). Tighten to 8
in-lbs torque.
Table 8
PNA-X to Test Set RF Cable Interface Connections
Numeric
RF Cables
Order
1
U3022-20092
2
U3022-20094
3
U3022-20091
4
U3022-20093
5
U3022-20092
6
U3022-20094
7
U3022-20091
8
U3022-20093
U3022AH10 User's and Service Guide
illustrate the interface cable configuration of the U3022AH10
Table 8 on page
25,
Figure 13 on page
26.
Figure 12 on page 26
8. Install the eight semi-rigid cables in the recommended sequence (please
From (PNA-X)
Port 1, CPLR ARM
Port 1, SOURCE OUT
Port 1, RCVR A IN
Port 1, CPLR THRU
Port 2, CPLR ARM
Port 2, SOURCE OUT
Port 2, RCVR B IN
Port 2 CPLR THRU
Figure 12
and
Figure 13 on page
refer to the corresponding cable number (last two
To (Test Set)
CPLR ARM
SOURCE OUT
A IN
CPLR THRU
CPLR ARM
SOURCE OUT
B IN
CPLR THRU
System Configurations
26.
Figure 12 on page
25
26.
Advertisement
Table of Contents
