Respironics BiPAP Service Manual page 126

Chapter 8
Component Removal/Installation
8-4
Figure 8-3: Removing Side Panels
3. Use a 5-mm nut driver remove the 2 jack screws from the 9-pin serial
port on the back panel.
4. Remove the ON/OFF switch bezel: gently apply downward pressure to
the top of the bezel allowing it to spring outward. Then, gently apply
upward pressure to the bottom of the bezel allowing it to spring
outward.
Jack screws (2)
Figure 8-4: Bipap Focus Back Panel
5. Tilt the bottom of the display assembly outward to separate it from the
bottom and top covers.
BiPAP Focus Ventilator Service Manual © Respironics, Inc.
ON/OFF switch bezel
REF 1029568 Rev B