Mazda 3 Workshop Manual page 689

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
1. Remove the plug hole plate (See
2. Remove the battery cover (See
3. Disconnect the negative battery cable.
4. Disconnect the wiring harness.
5. Remove the following parts.
(1) Front wheel and tire (RH). (See
(2) Engine under cover and splash shield (RH).
(3) Ignition coils. (See
(4) Ventilation hose.
(5) Cylinder head cover.
(6) Engine front cover lower blind plug.
(7) Engine front cover upper blind plug.
(8) Cylinder block lower blind plug.
6. Install the SST as shown in the figure.
Downloaded from
PLUG HOLE PLATE REMOVAL/INSTALLATION
BATTERY REMOVAL/INSTALLATION
GENERAL PROCEDURES
IGNITION COIL REMOVAL/INSTALLATION
https://carmanualshub.com/
[LF].)
(SUSPENSION).)
[LF].)
- automotive repair manuals website
[LF].)