Dtc P0602 [Z6] - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
• Start the engine.
• Access the ECT PID.
• Warm up the engine until the ECT PID
is more than 60 °C {140 °F}.
• Drive the vehicle more than 60 km/h {37.3
mph} for 1 min.
• Is the PENDING CODE for this DTC
present?
VERIFY AFTER REPAIR PROCEDURE
• Perform the "AFTER REPAIR
PROCEDURE".
10
(See AFTER REPAIR PROCEDURE
• Are any DTCs present?
DTC P0602
DETECTION
CONDITION
POSSIBLE CAUSE
Diagnostic procedure
STEP INSPECTION
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
1
• Has FREEZE FRAME DATA been
recorded?
Downloaded from
[Z6].)

DTC P0602 [Z6]

• No configuration data in the PCM.
Diagnostic support note
• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in the
first drive cycle.
• PENDING CODE is available if the PCM detects the above malfunction
condition.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.
• Complete configuration has not been completed
• PCM malfunction
Yes Go to the next step.
No
https://carmanualshub.com/
Go to the applicable DTC inspection.
Yes
(See DTC TABLE
No DTC troubleshooting completed.
PCM programming error
ACTION
Record the FREEZE FRAME DATA on the repair
order, then go to the next step.
- automotive repair manuals website
[Z6].)
B3E010200600W01