Fuel Tank Removal/Installation - Mazda 3 Workshop Manual

Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
350-410 kPa {3.57-4.18 kgf/cm
13. Stop the fuel pump.
14. Measure the fuel hold pressure after 5 min.
• If not within the specification, inspect the following:
- Fuel line for clogging or leakage
Fuel hold pressure
250 kPa {2.55 kgf/cm
15. Disconnect the SST.
16. Connect the quick release connector. (See
REMOVAL/INSTALLATION.)
17. Inspect all related parts by performing "AFTER SERVICE PRECAUTION". (See
PRECAUTION.)

FUEL TANK REMOVAL/INSTALLATION

Warning
• Repairing a fuel tank containing fuel is dangerous. Explosion or fire may cause death or serious
injury. Always properly steam clean a fuel tank before repairing it.
1. Park the vehicle on a level surface.
2. Follow "BEFORE SERVICE PRECAUTION" before performing any work operations to prevent fuel
from spilling from the fuel system. (See
Warning
• A person charged with static electricity could cause a fire or explosion, resulting in death or
serious injury. Before draining fuel, make sure to discharge static electricity by touching a vehicle.
3. Drain the fuel from the fuel tank using the following procedure:
(1) Disconnect the quick release connector (in the engine compartment). (See
CONNECTOR REMOVAL/INSTALLATION.)
(2) Attach a long hose to the disconnected fuel pipe and drain the fuel into a proper receptacle.
Downloaded from
2
, 50.8-59.4 psi}
2
, 36.2 psi} or more
QUICK RELEASE CONNECTOR
BEFORE SERVICE
https://carmanualshub.com/
AFTER SERVICE
PRECAUTION.)
- automotive repair manuals website
B3E011442110W01
QUICK RELEASE