Check And Replacement Of Oil In Gearbox, Axle Drive And Rear Axle Portals; Drainage And Inspection Holes - Zetor PROXIMA PLUS 2011 Series Operator's Manual

CHECK AND REPLACEMENT OF OIL IN
GEARBOX, AXLE DRIVE AND REAR
AXLE PORTALS
Oil level is checked in gear mechanisms
using a gauge rod in the filling hole lid (a)
that is located in left rear part of the
gearbox case.
A - Standard oil filling
B - Oil filling with additional 7 litres
Carry out checks
engine is stopped. Oil level shall
be within the gauge marks range.
Replace lost of damaged lid only
with original component that pro-
vides bleeding of the axle drive
case.
MAINTENANCE INSTRUCTIONS
E728

DRAINAGE AND INSPECTION HOLES

1. Drain plug of the gear mechanism.
2. Oil drain plug from the outlet for the
front driving axle.
3. * Brake chamber inspection screw.
4. Plug for drainage of oil from the axle
drive case.
5. Drain plugs of the left and right brake
chambers.
when the
E729
1. *Inspection and oil filling screw of the
2. Plug for draining of oil from the axle
3. *Inspection screw of the brake cham-
157
axle shaft case (applicable for stan-
dard adjustment of the portal).
shaft case.
ber.
* After screwing out the inspec-
tion screw the level of oil shall
reach lower edge of the inspec-
tion hole.
E730