Operation; Getting Ready For Operation; Supply Voltage - MICRO-EPSILON optoCONTROL 1200 Operating Instructions Manual

Operation

6.
6.1
The laser diode is active if the power supply is
ments the sensor typically requires a start-up time of 1 minute. Once this has elapsed the sensor will be in
measurement mode.
6.2
Nominal value: 24 VDC (12 ... 32 VDC, max. 100 mA).
MICRO-EPSILON Eltrotec GmbH recommends using an optional available power supply unit PS2020 for this
sensor, see A
i
optoCONTROL 1200/1201
Operation

Getting Ready for Operation

Install and assemble the light source and the receiver in accordance to the mounting
Connect an indicator or monitoring unit and the power

Supply Voltage

Use an error-free and stabilized power supply unit.
1.
Use the power supply only for measuring devices; do not use it at the same time for drives or similar
sources of impulse interference to avoid noise and interference.
supply, see 6.6.
on, see 6.6. To be able to produce reproducible measure-
instructions, see 5.
Page 60