Laser Safety - MICRO-EPSILON optoCONTROL 1200 Operating Instructions Manual

Laser Safety

2.
The optoCONTROL120x light source operates with a semiconductor laser with a wavelength of 670 nm (vis-
ible/red). the maximum optical power is ≤ 0.39 mW.
The sensors fall within laser class 1.
The accessible radiation is harmless under predictable conditions. For class 1 laser devices, impairment of
color vision and disturbances, e.g., from a glare effect, cannot be excluded.
Consequently, you can use Class 1 laser equipment without further protective measures.
Lasers of Class 1 are not subject to notification and a laser protection officer is not required.
The following laser warning labels must be attached to the cover (front side):
The laser warning labels for Germany are included in delivery and the versions valid for the users's country
must be attached before the device is put into operation for the first time. For other non German speaking
countries, an IEC and USA standard label has already been attached and enclosed in addition.
Laser label and laser warning sign, IEC and USA
The housing of the receiver and the light source may only be opened by the
For repair and survice purposes, the sensors must always be sent to the manufacturer.
optoCONTROL 1200/1201
Laser Safety
Class 1 Laser Product
IEC 60825-1: 2014
P<0.39 mW; λ=670 nm
COMPLIES WITH 21 CFR 1040.10 AND 1040.11
EXCEPT FOR CONFORMANCE WITH IEC 60825-1
ED. 3. AS DESCRIBED IN
LASER NOTICE NO. 56, DATED MAY 8. 2019.
LASER KLASSE 1
nach DIN EN 60825-1: 2015-07
P<0,39 mW; λ=670 nm
Laser label and laser warning sign, Germany
manufacturer, see 8.
Page 46