Notes On Ce Marking; Intended Use - MICRO-EPSILON optoCONTROL 1200 Operating Instructions Manual

Safety
Avoid permanent accumulation of dust or splashed water on the measurement system. Keep the optics clean
by blowing them off, if necessary, or use a protective housing.
Damage to light source and receiver
Avoid damage (scratches) to the protective windows of the light source and receiver by using proper clean-
ing methods or cleaning solvents.
> Inaccurate, false measurements
Do not touch the protective windows of the light source and receiver with the fingers. Wipe off any fingerprints
immediately.
> Inaccurate, false measurements
1.3
The following apply to optoCONTROL 120x measuring system:
- EU Directive 2014/30/EU
- EU Directive 2011/65/EU
Products which carry the CE mark satisfy the requirements of the EU directives cited and the relevant appli-
cable harmonized European standards (EN). The measuring system is designed for use in industrial environ-
ments.
The EU Declaration of Conformity and the technical documentation are available to the responsible authori-
ties according to the EU Directives.
1.4
- The optoCONTROL series 120x is designed for use in industrial areas. It is used for measuring diameters,
- The system must only be operated within the limits specified in the technical
- The system must be used in such a way that no persons are endangered or machines and other material
- Take additional precautions for safety and damage prevention for safety-related applications.
optoCONTROL 1200/1201

Notes on CE Marking

Intended Use

gaps, edges and light quantity
goods are damaged in the event of malfunction or total failure of the system.
data, see 4.
Page 44