Circutor CVM-C10 Instruction Manual page 62

 Programming the hysteresis value
When the desired value is shown on the screen, move onto the next digit by pressing the key
modify the other values.
If you press the
modify the previously programmed values again.
To validate the data, press
Press key
Programming the latch

To validate the data, press
Press key
Note: If the device is reset, the status of alarms is deleted and all alarms will return to the programmed
standby status, provided that the condition that triggered them has been resolved.
 Programming the time delay 2
When the desired value is shown on the screen, move onto the next digit by pressing the key
modify the other values.
62
The hysteresis value, i.e., difference between the alarm connection and
disconnection value, in %, is programmed on this screen.
Press key
prog icon will be displayed on the bottom of the screen.
To enter or modify the value, press the
the value of the flashing digit.
key after changing the last digit, it will jump back to the first digit so you can
for 3 seconds and the prog icon will disappear from the display.
to access the next programming step.
The interlocking is selected on this screen, i.e., if the alarm is
interlocked after it has been tripped, even when the condition that
triggered it has disappeared.
Press key
be displayed on the bottom of the screen.
Press key
for 3 seconds and the prog icon will disappear from the display.
to access the next programming step.
The alarm disconnection delay is programmed on this screen in
seconds.
Press key
prog icon will be displayed on the bottom of the screen.
To enter or modify the value, press the
the value of the flashing digit.
for 3 seconds to edit the hysteresis value selection. The
for 3 seconds to edit the selection. The prog icon will
to browse the two options (Yes and No).
for 3 seconds to edit the maximum value selection. The
CVM-C10
key repeatedly, increasing
key repeatedly, increasing
Instruction Manual
to
to