4�9�22� Cost Ratio Of Consumed Energy; 4�9�23� Programming Alarm 1 (Relay 1) - Circutor CVM-C10 Instruction Manual

4�9�22� COST RATIO OF CONSUMED ENERGY
When the desired value is shown on the screen, move onto the next digit by pressing the key
modify the other values.
If you press the
modify the previously programmed values again.
Press key
To validate the data, press
The programmed value will be deleted if the entered value is higher than the maximum programming
value.
Maximum programming value: 1.9999.
Minimum programming value: 0.
Press key
4�9�23� PROGRAMMING ALARM 1 (RELAY 1)
Note: Configuration parameters not available for the CVM-C10-FLEX model.
To enter or modify the value, press the
When the desired value is shown on the screen, move onto the next digit by pressing the key
modify the other values.
When you enter the code of a variable on the display, the symbols for that variable will be activated.
Set the value to 00 if you do not wish to program a variable.
58
The cost per kWh of electricity of the three tariffs of the unit is
calculated on this screen.
Press key
icon will be displayed on the bottom of the screen.
To enter or modify the value, press the
the value of the flashing digit.
key after changing the last digit, it will jump back to the first digit so you can
to browse the different tariffs.
for 3 seconds and the prog icon will disappear from the display.
to access the next programming step.
The variable code is selected on this screen, depending on
which will control alarm relay 1.
Press key
will be displayed on the bottom of the screen.
for 3 seconds to edit the cost ratio selection. The prog
for 3 seconds to edit the code selection. The prog icon
key repeatedly, increasing the value of the flashing digit.
CVM-C10
key repeatedly, increasing
Table 15,
Instruction Manual
to
to