Circutor CVM-C10 Instruction Manual page 60

 Programming the maximum value
When the desired value is shown on the screen, move onto the next digit by pressing the key
modify the other values.
In the case of some parameters (
press key
Press key
When the decimal point is in the desired position, press the key
now the key
Note: Pay special attention when programming the Generation Power (displayed with negative values).
Example: If you wish to enter a generation power alarm with limits between 2 kW and 1 kW, program
the following as the maximum value : - 1 kW and the following as the minimum value : - 2 kW.
To validate the data, press
Press key
60
The maximum value: the alarm is activated when this value is
exceeded.
Press key
prog icon will be displayed on the bottom of the screen.
To enter or modify the value, press the
the value of the flashing digit.
Table 17
after modifying the last digit and the decimal point will start flashing.
repeatedly to modify the position of the decimal point.
we can set a positive or negative value.
for 3 seconds and the prog icon will disappear from the display.
to access the next programming step
Table 17: Decimal point and units of the alarm parameters�
Types of parameters
Voltage
Current
Frequency
Power
Power factor
Cosine φ
Maximum current demand
Maximum power demand
THD
for 3 seconds to edit the maximum value selection. The
), you can modify the position of the decimal point. To do so,
Units
2000 V
200.0 V
20.00 kV
2.000 kV
A
Hz
kW
PF
φ
A
kW
%
key repeatedly, increasing
to end the programming, pressing
Decimal point
Programmable
Programmable
Fixed
Programmable
Fixed
Fixed
Programmable
Programmable
Fixed
Instruction Manual
CVM-C10
to