4�3�- Display; 4�3�1� Cos Φ - Pf (Power Factor) Bar - Circutor CVM-C10 Instruction Manual

CVM-C10
4�3�- DISPLAY
The device has a backlit LCD display showing all the parameters listed in
The display is divided into four areas (
 The area with data per phase displays the instantaneous, maximum and minimum values of
each phase being measured or calculated by the device.
The total data area displays the totals of the values being measured or calculated by the
device.
Analogue bar, displays the % of the current power of the installation.
φ - PF Bar
Cos
4�3�1� cos
φ - PF (POWER FACTOR) BAR
This bar displays the value of the installation's cos
The parameter that will be displayed is selected on the programming menu. (
φ - PF bar on the display"
Note: This bar will not be displayed in the IEC and IEEE measurement conventions.
Instruction Manual
Figure 23
Figure 23: CVM-C10 Display areas
, displays the value of the system's Cos
Figure 24: Cos φ - PF Bar
)
):
or power factor in real time.
φ
φ or power factor in real time.
.
Table 3
"4.9.14. Selecting the Cos
35