Saadat Respina P1 User Manual page 31

Vt Tidal volume delivered to patient during each inspiration
T Inspiration time
i
PEEP Positive end expiratory pressure
P Pressure more than PEEP that applies to mandatory breaths in pressure modes
control
P Pressure more than PEEP that applies to spontaneous breaths.
support
P High pressure level in APRV mode
high
P Low pressure level in APRV mode
low
T Time at high pressure level in APRV mode
high
T Time at low pressure level in APRV mode
low
This parameter sets percentage of peak inspiratory flow in spontaneous breath and
pressure based mode necessary to terminate
% Esens
When patient inspiratory flow falls below adjusted Esens by user, exhalation
begins. The maximum inspiration time in assisted mode is 2 secs for adults and 1.5
sec for pediatrics.
This parameter determines the time required to rise to P
Rise Time
Available options for this parameter are Slow, Med and Fast.
Breath Trigger Selecting the pattern of patient inspiratory effort in terms of flow or pressure.
The patient breathing effort will result in pressure drop and this reduction is
Pressure detected by pressure sensor. The user specifies a threshold based on the patient
Triggering condition to evaluate pressure variations relative to the threshold. If pressure
violates the specified threshold, the ventilator will detect patient respiratory effort.
In this method of breath triggering the user specifies a threshold based on the
Flow Triggering patient condition to evaluate flow variations relative to the threshold. If flow
violates the specified threshold, the ventilator will detect patient respiratory effort.
It is a percentage of inhalation time and sets the time that inspiration is paused after
Pause set tidal volume has been delivered. During this time no air is inhaled or exhaled by
the patient. This parameter is available inVCV and V-SIMV modes.
inhalation
and initiate exhalation.
in pressure breaths.
control
31