Chapter 3 Installation - Ametek Dycor CG1000-RTP User Manual

INSTALLATION
This chapter shows you how to install your CG1000-RTP oxygen analyzer.
It includes the following:
•
Inspect Shipping Contents
•
Mechanical Installation
- Sample gas requirements
- Sample gas set-up
- Calibration gas set-up
- PPM measurement suggestions
•
Electrical Installation
- Current output connections
- Alarm contact connections
- RS-232 communications
- Select 115/230 Volt operation
•
Start-Up and User Interface
There are no operator-serviceable components inside the CG1000-
RTP. Never open the analyzer cover. Refer servicing to qualified
personnel.
Remove any packing material from the sensor and control unit. Check

for damage. If any damage is found, notify the shipper.
NOTE
|
Installation & Start-Up 3-1