Chapter 3 Installation - Ametek Dycor CG1100 Series User Manual

INSTALLATION
This chapter includes the following:
•
Mechanical Installation
- Sample gas requirements
- Sample gas set-up
- Calibration gas set-up
- PPM measurement suggestions
•
Electrical Installation
- Wiring
- Alarm contact connections
- Output Wiring
- Status LEDs and Alarms
- Connection to Line Power
There are no operator-serviceable components inside the CG1100.
Never open the analyzer cover. Refer servicing to qualified personnel.
Remove any packing material from the sensor and control unit. Check

for damage. If any damage is found, notify the shipper.
NOTE
Installation | 3-1