Chapter 4 User Interface; Passwords - Ametek Dycor CG1000-RTP User Manual

Passwords

This menu option allows you to define a system password which limits
access to certain menu options to authorized personnel only. You can also
use this menu option to disable the password requirement. By default, the
system password is disabled. If you don't want to enable a system pass-
word, skip this section.

NOTE
1. From the Setup key menu, select Passwords.
2. Enter a four digit password. To protect the identification of the pass-
word, the numbers you enter are displayed as blocks rather than as
text. You are then prompted to reenter the password to verify it.
Reenter the password.

NOTE
USER INTERFACE
If you cannot remember the correct password, call AMETEK/Dycor
and a service password will be provided so you can access the Pass-
word option and enter a new system password.
Enter new password
Reenter to Verify
To later disable or change the system password, you must first enter
the old password to access this menu option, then change or disable
the password (0000 disables the password).
Controller / User Interface
|
4-1