Table of Contents
Advertisement
Electrical Installation
current output connections
Alarm contact connections
Rs-232 communications
select 115/230 volt operation
Current Output Connections
current output connections are labeled as follows on the J8 connector of
the cg1000-RTP (Figure 3-5):
Figure 3-5.
iouT1 +
iouT1-
iouT2 +
iouT2-
These current outputs are referenced as current outputs 1 and 2 in soft-
ware.
NOTE
current outputs 1 and 2 are capable of driving up to 1200 ohm loads.
These two current outputs (1 and 2) are isolated from the analyzer but are
not isolated from each other.
J7 and J8 pinouts - rear of analyzer.
Pin 3
Pin 4
Pin 1
Pin 2
Be sure to observe polarity when connecting current out-
put devices to these terminals.
|
Installation & Start-Up
3-7
Advertisement
Table of Contents
Troubleshooting
