Appendix A Serial Communications; Communication Protocol - Ametek Dycor CG1000-RTP User Manual

SERIAL COMMUNICATIONS

Communication Protocol

Communicating to the CG1000-RTP requires the following parameter set-
ting:
In addition, the baud rate on the CG1000-RTP analyzer must match the
baud rate of the host device. Baud rates are user-programmable. See the
"Communication" section in the Setup key chapter for help on defining
control unit baud rates.
The communication protocol is a basic master/slave, command/response
protocol. The master initiates the communication transfer. There is one
master on the communication line but there can be multiple CG1000-RTP
analyzers acting as slaves. Up to 32 analyzers can be connected on one
network.
8 Data bits
1 Stop bit
No Parity
|
Serial Communications A-1