Anritsu Site Master S331L Scpi Programming Manual page 65

Chapter 4 — Cable & Antenna Analyzer Mode Commands
[:SENSe]:SWEep:RFIMmunity HIGH|LOW|1|0
[:SENSe]:SWEep:RFIMmunity?
Cmd Description: Command sets the RF immunity state.
Query Description: Query returns the RF immunity state, 1 for low immunity and 0 for
Param Range: HIGH|LOW|1|0
Default Value: LOW|1
Example: To set RF immunity to low:
[:SENSe]:SWEep:TYPE CONTinuous|SINGle|EXTernal
Cmd Description: Command sets the sweep trigger type to be Internal (Continuous or
Param Range: CONTinuous|SINGle|EXTernal
Default Value: CONTinuous
Example: To set the sweep trigger type to internal single sweep:
Notes: External Trigger setting is not available on all models.
[:SENSe]:TRACe:SELect 1|2
[:SENSe]:TRACe:SELect?
Cmd Description: Command sets the active trace.
Query Description: Query returns the active trace.
Param Range: 1|2
Default Value: 1
Example: To set active trace to trace 2:
S331L PM
high immunity.
:SWE:RFIM LOW
Single) or External.
:SWE:TYPE SING
:TRAC:SEL 2
PN: 10580-00322 Rev. F 4-29