Calculate:marker#:Valley; Calculate:marker#:Valley:bounded; Calculate:marker#:X <Value>{Hz|Khz|Mhz|Ghz,M|Cm|Mm,Ft,Ps|Ns|Us|Ms|S; Calculate:marker#:X - Anritsu Site Master S331L Scpi Programming Manual

:CALCulate:MARKer#:VALLey

Cmd Description: This command sets specified marker to the trace valley value.
Example: To set marker 5 to the valley of the trace:
Notes: Replace '#' with the required marker number. Check User Guide for the

:CALCulate:MARKer#:VALLey:BOUNded

Cmd Description: This command sets specified marker to the trace valley value between
Example: To set marker 5 to the valley between markers 1 and 2:
Notes: Replace '#' with the required marker number. Check User Guide for the

:CALCulate:MARKer#:X

<value>{Hz|kHz|MHz|GHz,m|cm|mm,ft,ps|ns|us|ms|s}
:CALCulate:MARKer#:X?
Cmd Description: Command sets the position for the specified marker in the current
Query Description: Query returns the marker position for the specified marker. For a delta
Param Type: Float
Param Description: Frequency, distance, or time
Default Value: Model-dependent
Default Units: Hz
Example: To set marker 2 frequency to 1 GHz:
Notes: Replace '#' with the required marker number. Check User Guide for the
4-12
Chapter 4 — Cable & Antenna Analyzer Mode Commands
:CALC:MARK5:VALL
number of supported markers in each mode.
two markers. Markers 5 and 7 will search for the valley between
markers 1 and 2. Markers 6 and 8 will search for the valley between
markers 3 and 4.
:CALC:MARK5:VALL:BOUN
number of supported markers in each mode. If any marker other than 5,
6, 7, or 8 is specified, the bounded marker will be set to 5 by default.
sweep domain. For delta marker, it sets the relative position to the
reference marker. Verify that the appropriate unit is used. Time units
are available only if option 2 is installed.
marker, query returns the position relative to the reference marker.
:CALC:MARK2:X 1 GHZ
number of supported markers in each mode.
PN: 10580-00322 Rev. F S331L PM