Calculate#:Limit:lower:segment:stop:y <Amplitude; Calculate#:Limit:lower:segment:stop:y; Calculate#:Limit:lower:segment:total; Calculate#:Limit:lower:y <Amplitude>{Db,S|Ms|Ns|Ps - Anritsu Site Master S331L Scpi Programming Manual

:CALCulate#:LIMit:LOWer:SEGMent:STOP:Y <amplitude>

:CALCulate#:LIMit:LOWer:SEGMent:STOP:Y?

Cmd Description: Command sets the lower limit line Y stop value for active segment.
Query Description: Query returns the lower limit line Y stop value for active segment.
Param Type: Float
Default Units: Current active trace y-axis units
Example: To set limit stop amplitude to 20 dB for trace 1:
Notes: Replace '#' with the required trace number. Check User Guide for the

:CALCulate#:LIMit:LOWer:SEGMent:TOTal?

Query Description: Query returns the total segments in the lower limit for the given trace.
Example: To query how many lower limit segments are currently available for
Notes: Replace '#' with the required trace number. Check User Guide for the
:CALCulate#:LIMit:LOWer:Y <amplitude>{dB,s|ms|ns|ps}

:CALCulate#:LIMit:LOWer:Y?

Cmd Description: Command sets the lower limit line value. In group delay mode, the
Query Description: Query returns the lower limit line value.
Param Range: x[,dB]
Default Units: Current active trace y-axis units
Example: To set limit amplitude to 20 dB for trace 1:
Notes: Replace '#' with the required trace number. Check User Guide for the
4-4
Chapter 4 — Cable & Antenna Analyzer Mode Commands
:CALC1:LIM:LOW:SEGM:STOP:Y 20
number of supported traces in each mode.
trace 1:
:CALC:LIM:LOW:SEGM:TOT?
number of supported traces in each mode.
value is in units of time.
:CALC1:LIM:LOW:Y 20
number of supported traces in each mode.
PN: 10580-00322 Rev. F S331L PM