Source:power Low|High; Source:power; Status:operation; Trace[:Data]? {1|2 - Anritsu Site Master S331L Scpi Programming Manual

:SOURce:POWer LOW|HIGH

:SOURce:POWer?

Cmd Description: Command sets the source power level. Default is high.
Query Description: Query returns the source power level, LOW or HIGH.
Example: To set source power to low:

:STATus:OPERation?

Query Description: Queries sweep status. This is used in combination with
Example: To query sweep status:

:TRACe[:DATA]? {1|2}

Query Description: Query returns raw trace data in real and imaginary format.
Param Type: Integer
Param Description: Optional Param: Trace number, default is 1.
Param Range: 1|2
Example: To get trace 1 data:
Notes: The format of the block data that is returned can be specified by the
4-22
Chapter 4 — Cable & Antenna Analyzer Mode Commands
:SOUR:POW LOW
:INITiate[:IMMediate]. Sweep complete bit is the bit 8. Query returns
256 if sweep has completed. Otherwise, it returns 0.
:STAT:OPER?
:TRAC?
command :FORMat[:READings][:DATA]. The response begins with an
ASCII header that specifies the number of data bytes. It appears in the
format #AX, where A is the number of digits in X, and X is the number
of bytes that follow the header. Each data point is separated by a
comma-delimiter. The returned numbers, which are independent of the
Measurement Mode that is associated with the trace, are complex
measurement data pairs (Real and Imaginary) for each point of the
trace. A 517 point trace therefore has a total of 1034 values that get
transferred.
PN: 10580-00322 Rev. F S331L PM