Initiate#:Data? Fdata|Sdata|Fmem|Smem; Initiate:continuous; Initiate:hold; Initiate[:Immediate] - Anritsu Site Master S331L Scpi Programming Manual

Handheld cable and antenna analyzer
Hide thumbs Also See for Site Master S331L:
Table of Contents

Advertisement

Chapter 4 — Cable & Antenna Analyzer Mode Commands

:INITiate#:DATA? FDATa|SDATa|FMEM|SMEM

Cmd Description: Command triggers a sweep and returns the data block of the specified
Example: To trigger a sweep and wait for Formatted data to be returned:
:INITiate:CONTinuous OFF|ON|0|1

:INITiate:CONTinuous?

Cmd Description: Command sets the sweep type between single sweep and continuous
Query Description: Query returns the sweep type, single or continuous. Query returns 1 for
Param Range: OFF|ON|0|1
Default Value: ON|1
Example: To set the sweep type to single sweep:
:INITiate:HOLD OFF|ON|0|1

:INITiate:HOLD?

Cmd Description: Command sets the sweep state between run and hold. This command is
Query Description: Query returns the sweep state, run or hold. Query returns 1 for hold
Param Range: OFF|ON|0|1
Default Value: OFF|0
Example: To set the sweep state to hold:

:INITiate[:IMMediate]

Cmd Description: Command triggers a single sweep if in single sweep mode. If the system
Example: To trigger a sweep:
S331L PM
trace at the end of sweep. If the system is in continuous mode, then this
command is ignored.
:INIT1:DATA? FDAT
sweep.
continuous sweep, and returns 0 for single sweep.
:INIT:CONT OFF
ignored in external trigger mode.
mode, and returns 0 for run mode.
:INIT:HOLD ON
is in continuous mode, then this command is ignored.
:INIT
PN: 10580-00322 Rev. F
4-21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Site Master S331L and is the answer not in the manual?

Table of Contents