Calculate:limit:message; Calculate:limit:message:result; Calculate:limit:mode; Calculate:limit:preset - Anritsu Site Master S331L Scpi Programming Manual

Chapter 4 — Cable & Antenna Analyzer Mode Commands
:CALCulate:LIMit:MESSage OFF|ON|0|1

:CALCulate:LIMit:MESSage?

Cmd Description: Command sets the limit message state. Displays a Pass/Fail message to
Query Description: Query returns the limit message state.
Param Range: OFF|ON|0|1
Default Value: OFF|0
Example: To set limit message on:

:CALCulate:LIMit:MESSage:RESult?

Query Description: Query returns 0 if limit line says Fail. Otherwise, it returns 1 if limit
Example: To get limit line Pass/Fail result:

:CALCulate:LIMit:MODe

Cmd Description: Command changes the limit line to either Line or Segmented mode.
Example: To change the limit line mode

:CALCulate:LIMit:PRESet

Cmd Description: Command presets the limit line to its default state.
Example: To perform limit line preset:

:CALCulate:LIMit:TYPE 0|1

:CALCulate:LIMit:TYPE?

Cmd Description: Command sets the active limit line type. 0 for upper limit and 1 for
Query Description: Query returns the active limit line type.
Param Range: 0|1
Default Value: 0
Example: To set the active limit to lower limit:
S331L PM
indicate whether the trace crosses the limit line.
:CALC:LIM:MESS ON
line says Pass.
:CALC:LIM:MESS:RES?
:CALC:LIM:MOD SEGM
:CALC:LIM:PRES
lower limit.
:CALC:LIM:TYPE 1
PN: 10580-00322 Rev. F 4-9