Install The Pressure And Tank Hoses - Raven AutoBoom XRT Installation Manual

INSTALL THE PRESSURE AND TANK HOSES

Refer to Figure 14 on page 21 while performing the following steps.
1. Disconnect the machine pressure hose from the machine hydraulic valve.
FIGURE 10. Pressure Hoses with Tee Fitting Installed on Machine Hydraulic Valve
2. Install a -8 ORFS M/M/F swivel run tee fitting (P/N 333-0012-028) in the machine pressure port.
3. Attach the machine pressure hose to the opposite end of the installed tee fitting.
016-0236-001 Rev. E
WARNING
Hydraulics are under pressure. Care should
always be taken with a system that has been
pressurized. When disconnecting or purging
hydraulic hoses, be aware that the hydraulic
fluid within the machine system may be
extremely hot and under high pressure.
CAUTION
When installing hydraulics or performing
diagnostics, maintenance, or routine service,
ensure precautions are taken to prevent any
foreign material or contaminants from being
introduced into the machine hydraulic
system.
Objects or materials that are able to bypass
the machine hydraulic filtration system will
reduce performance and possibly cause
damage to the hydraulic valve.
HYDRAULIC SYSTEM INSTALLATION
To AutoBoom
Valve
Swivel Run
Tee
To AutoBoom
Valve
Existing Hoses
17