Table of Contents
Advertisement
INSTALL THE PRESSURE AND TANK HOSES
FIGURE 2. Pressure Hose Installed
1. Disconnect the machine's pressure hose from the machine's hydraulic valve.
2. Install a 13/16" ORFS M/M/F swivel run tee fitting (P/N 333-0012-028) in the machine's pressure port.
3. Attach the machine's pressure hose to the opposite end of the installed tee fitting.
4. Connect the 90° end of the supplied hydraulic hose (P/N 214-1000-311) to the 90° end of the tee fitting.
5. Connect the straight end of the installed hydraulic hose to Port P of on the AutoBoom valve.
P/N 016-0230-047 Rev. C
WARNING
Hydraulics are under pressure. Care should
always be taken with a system that has been
pressurized. When disconnecting or purging
hydraulic hoses, be aware that the hydraulic fluid
within the machine's system may be extremely
hot and under high pressure.
CAUTION
When installing AutoBoom hydraulics or
performing diagnostics, maintenance, or routine
service, ensure precautions are taken to prevent
any foreign material or contaminants from being
introduced into the machine's hydraulic system.
Objects or materials that are able to bypass the
machine's hydraulic filtration system will reduce
performance and possibly damage the
AutoBoom hydraulic valve.
HYDRAULIC SYSTEM INSTALLATION
15
Advertisement
Table of Contents
