120' Steel Boom - Raven AutoBoom XRT Installation Manual

C 4
HAPTER
5. Use the provided hardware to install the tilt sensor link to the tilt sensor arm. When the installation is complete
the tilt sensor arm should be perpendicular to the tilt sensor bracket.
6. Attach the other rod end to the rod end bracket with M6 nylock nut.
7. Tighten all hardware.
8. Repeat step 1 through step 7 to install the left boom tilt sensor.

120' STEEL BOOM

1. Remove the cover over the factory installed tilt and fold sensors.
FIGURE 19. Remove Cover
2. Disconnect the factory wire harness connectors.
3. Connect the Left Tilt position connector to the factory installed Tilt position sensor.
4. Connect the Left Fold position connector to the factory installed Left Fold position sensor.
36 AutoBoom® XRT Installation Manual for Case IH Patriot 3xx0/44x0 and Trident 5550 (MY 2017-2021)