Installation Overview - Raven AutoBoom XRT Installation Manual

INSTALLATION OVERVIEW

The image below shows approximate installation locations for the sensor and nodes. Depending on machine
configuration and desired performance some of the sensors and dampers may not be installed.
FIGURE 2. Example Component Locations
1. Radar Sensors
2. ABM Node
3. REM Node
4. Hydraulic Valve
5. Tilt Sensor
6. Rotary Sensor
7. Variable Damper
8. Proximity Sensor
For additional information on the component installation, refer to the:
• Hydraulic valve mounting and installation instructions in Chapter 3, Hydraulic System Installation.
• Rotary sensor installation instructions in Center Rack Rotary Sensor Installation section on page 31.
• Variable damper installation instructions in Optional Damper Installation section on page 22.
• REM node installation instructions in Mount the AutoBoom® XRT Valve section on page 15.
• ABM node installation instructions in AutoBoom® ABM Node Installation section on page 41.
• Tilt sensor installation instructions in either the 90' and 100' Boom section on page 35, 120' Steel Boom section
on page 36, or the 120', 132', and 135' Aluminum Boom section on page 38.
• Outer sensor installation information in 90', 100', and 120' Steel Boom section on page 25.
• Inner sensor installation information in 90', 100', and 120' Steel Boom section on page 25.
• Center sensor installation instructions in 90', 100', and 120' Steel Boom section on page 25.
• Proximity sensor installation instructions in Proximity Sensor section on page 40.
016-0236-001 Rev. E
8
5
1
6 2 7 8
3, 4 5
INTRODUCTION
1
7