Raven AutoBoom XRT Installation Manual page 27

FIGURE 17. Detailed Damper Installation Location
Center
Rack
3. Using the provided 1/2" - 13 U-bolts, loosely install one of the damper mounting brackets to the front of the
center rack cross tube with the two holes facing towards the centerline of the machine.
FIGURE 18. Damper Brackets Loosely Installed with Damper Spacing Template
4. Using the provided U-bolts, loosely install the other damper mounting bracket to the back of the center frame
vertical tube with the two holes facing towards the outside.
5. Using the provided 5/8" clevis pins, install the damper spacing templates (P/N 107-0235-029) to both holes on
each of the mounting brackets. It may be necessary to slide the brackets to install the template.
NOTE: The bracket installed on the vertical member should be as low as possible. Slide the upper bracket to
work with the lower bracket as low as possible.
6. Adjust the brackets so they are level to the machine.
7. Tighten the U-bolts to secure the brackets in place.
016-0236-001 Rev. E
Existing Cable
HYDRAULIC SYSTEM INSTALLATION
Center
Frame
23