Table of Contents
Advertisement
Chapter 3
Install the Planter Row Unit Pressure and Tank Hoses
Planter Row Unit Pressure and Tank Hoses Installed
FIGURE 16.
Refer to the supplied machine-specific hydraulic installation sheet included with the OmniRow installation kit to
install the planter row unit pressure and tank hoses.
Important:
Pay close attention to the hydraulic hose part numbers on the diagram and the locations in
which each must be installed. Install all pressure hoses before installing tank hoses.
Note:
As illustrated in the installation sheet, there are tee fittings installed to connect the pressure and
tank hoses to the open center pressure-reducing valve. Additional 45° and 90° elbow fittings are
also supplied to assist in routing the hydraulic hoses around obstacles. Install these additional
fittings as needed.
Install the supplied hydraulic hoses on each end of the installed tee fittings in Port 2 of the PWM valves,
1.
continuing from one row unit to the next, until all pressure hoses are installed.
Install the supplied hydraulic hoses on each end of the installed bulkhead tee fittings installed on the end of
2.
the PWM valve mounting brackets, continuing from row unit to the next, until all tank hoses are installed.
Install the Open Center Pressure-Reducing Valve Pressure and
Tank Hoses
Pressure-Reducing Valve Pressure and Tank Hoses Installed
FIGURE 17.
16
John Deere Individual Row Control OmniRow Installation Manual
Pressure
Tank
Advertisement
Table of Contents
