Install The Left And Right Cylinder Hoses - Raven AutoBoom XRT Installation Manual

INSTALL THE LEFT AND RIGHT CYLINDER HOSES

1. Verify the booms are cradled.
IMPORTANT: If booms are not cradled, the booms will drop when the hydraulic hoses are disconnected.
FIGURE 12. Left and Right Cylinder Hoses Installed
To Left Tilt
Cylinder
Rod End
To Right Tilt
Cylinder
Rod End
2. Trace the machine left and right cylinder tilt hoses from the rod-end of the tilt cylinders to the machine
hydraulic valve.
3. Disconnect the machine left and right cylinder tilt hoses from the machine hydraulic valve.
4. Install -6 ORFS M/M/F swivel run tee adapter fittings (P/N 333-0012-069) in the tilt hose ports of the machine
hydraulic block.
5. Connect the machine right tilt hose to the opposite end of the tee fitting installed in the right tilt port of the
machine hydraulic valve.
6. Connect the 90° end of the supplied hydraulic hose (P/N 214-1000-494) to the 90° end of the installed tee
fitting.
7. Connect the straight end of the installed hydraulic hose to the installed fitting in Port RC of the AutoBoom
valve.
8. Connect the machine left tilt hose to the opposite end of the tee fitting installed in the left tilt port of the
machine hydraulic valve.
9. Connect the 90° end of the supplied hydraulic hose (P/N 214-1000-494) to the 90° end of the installed tee
fitting.
10. Connect the straight end of the installed hydraulic hose to the installed fitting in Port LC of the AutoBoom
valve.
016-0236-001 Rev. E
HYDRAULIC SYSTEM INSTALLATION
To Left Tilt
Base End
To Right Tilt
Base End
19