Raven AutoBoom XRT Installation Manual page 28

C 3
HAPTER
8. Remove the damper spacing template.
NOTE: It will be necessary to compress the dampers to fit into the spacing. To do this:
•
connect two ends of a ratchet strap to each other
•
place the ratchet strap around the damper like a belt
•
tighten the ratchet strap until the damper is the desired length
9. With the cylinder end of the damper at the top, use the provided 5/8" clevis pins to install the top damper in
the top holes on each bracket.
FIGURE 19. Installed Dampers
Damper
Mounting
Bracket
10. Use the provided 5/8" clevis pins to install the bottom damper in the bottom holes in each bracket.
11. Install the cotter pins in the ends of all the 5/8" clevis pins.
24 AutoBoom® XRT Installation Manual for Case IH Patriot 3xx0/44x0 and Trident 5550 (MY 2017-2021)
Damper
Damper
Damper
Mounting
Bracket