Raven AutoBoom XRT Installation Manual page 51

1. Plug gray 23 pin plug on the XRT cable (P/N 115-0235-113) to the mating connector on the bottom of the REM
node.
2. Plug black 23 pin plug on the XRT cable to the mating connector on the bottom of the REM node.
3. Plug black 35 pin plug on the XRT cable to the mating connector on the bottom of the REM node.
4. Route the connector labeled ABM along the machine hoses and towards the ABM node.
5. Connect the connector labeled AMB to the AutoBoom node.
6. Use the provided 12-pin green DTM plug to protect the unused connector of the ABM node.
FIGURE 9. AutoBoom Cable Connected to Node
7. Connect the RIGHT CYLINDER POSITION plug to the 4-pin receptacle on the Patriot Sensor Tee cable (P/N 115-
0235-104).
FIGURE 10. Machine Tilt Sensor
Cylinder
Position
Plug
016-0236-001 Rev. E
Terminate
WIRING INSTALLATION
47