Install Fittings On The Autoboom® Xrt Valve; Remove The Orifice Fittings (For Machines With Autoboom® Already Installed) - Raven AutoBoom XRT Installation Manual

C 3
HAPTER
INSTALL FITTINGS ON THE AUTOBOOM® XRT VALVE
Before mounting the AutoBoom XRT valve on the machine, install the proper fittings in the valve.
Refer to the following table to install the fittings in the appropriate ports of the AutoBoom XRT valve:
Fitting - -6 ORFS (M) to -8 SAE O-Ring (M) 90° Elbow
Fitting - -6 ORFS (M) to -6 SAE O-Ring (M) Straight Adapter
Fitting - -8 ORFS (M) to -8 SAE O-Ring (M) Straight Adapter
Fitting - -6 Hex 9/16" O-Ring Plug
REMOVE THE ORIFICE FITTINGS (FOR MACHINES WITH AUTOBOOM®
ALREADY INSTALLED)
On machines with AutoBoom already installed, it is necessary to remove the existing AutoBoom node and
mounting plate as well as remove the orifice fittings in the AutoBoom valve. The AutoBoom valve will be reused
for the AutoBoom XRT installation.
1. Locate Ports 3A and 3B on the AutoBoom valve.
FIGURE 1. Port 3A and 3B Location
Port 3B
Port 3A
2. Remove the coils from the solenoids near Ports 3A and 3B to gain easy access to those ports.
12 AutoBoom® XRT Installation Manual for Case IH Patriot 3xx0/44x0 and Trident 5550 (MY 2017-2021)
Fitting Part Number Port
LF CYL RTN,
333-0012-165
RT CYL RTN
333-0012-084 LC, RC
333-0012-168 P, T
333-0012-194 LV, RV