Raven AutoBoom XRT Installation Manual page 54

C 5
HAPTER
4. Connect the RIGHT SOLENOID (PORT 4B) plug on the cable to port 5B on the AutoBoom XRT valve.
5. Connect the RIGHT PROP (PORT 13A) plug on the cable to port 13A on the AutoBoom XRT valve.
6. If dampers are installed, connect the plug labeled DAMPER 1 to the mating receptacle on the top damper.
7. If dampers are installed, connect the plug labeled DAMPER 2 to the mating receptacle on the bottom damper.
8. Remove dust caps from the height sensor connectors on the factory AutoFold cable.
9. Connect the INNER, MID, and OUTER height sensor connectors to the appropriate height sensors installed on
the boom.
10. Locate the provided center rack rotation sensor adapter cable (P/N 115-0235-167).
11. Connect one end to the height sensor installed on the center rack.
12. Connect the mating end to the "CTR RADAR" connector on the factory AutoFold center rack cable.
13. Route the center rack rotation sensor adapter cable to the center rack rotation sensor.
14. Connect one end to the installed rotation sensor.
15. Connect the other end to the "CENTER ROTARY SENSOR" connector on the factory AutoFold center rack cable.
50 AutoBoom® XRT Installation Manual for Case IH Patriot 3xx0/44x0 and Trident 5550 (MY 2017-2021)