Install The Fittings In The Autoboom Valve; Mount The Autoboom Valve - Raven AutoBoom Installation Manual

Metalfor 2200, 2500, and 3000 series

Hide thumbs Also See for AutoBoom:

Table of Contents

Chapter 3

Install the Fittings in the AutoBoom Valve

Before mounting the AutoBoom valve on the machine, install the proper fittings on the valve. This prepares the

valve for installation and simplifies the hose connection process later in the procedure. Refer to the following

steps and table to install the fittings in the appropriate ports of the AutoBoom valve.

Note:

The following instructions assume you are looking at the AutoBoom valve with the LC, RC, LV, and

RV ports facing you.

Remove the steel plug fitting from Port T on the right side of the AutoBoom valve (P/N 063-0131-126).

Remove the plastic plug from Port T on the left side of the valve and install the steel plug fitting.

Fitting - 9/16" JIC (M) to 9/16" SAE O-Ring (M) Straight Adapter

Fitting - 3/4" JIC (M) to 3/4" SAE O-Ring (M) Straight Adapter

Fitting - 9/16" O-Ring to 11/16" Hex Plug

AutoBoom Valve Mounted on the Valve Mounting Plate

FIGURE 1.

Secure the AutoBoom valve (P/N 063-0131-126) to the mounting plate (P/N 107-0171-802) using four 5/16"

hex bolts (P/N 311-0052-104) and four 5/16" lock washers (P/N 313-1000-019).

Fitting

Metalfor 2200, 2500, and 3000 Series AutoBoom™ Installation Manual

Part Number

Port

333-0012-045

LC, RC

Right T,

333-0012-093

P, EF

333-0012-194

LV, RV

Table of Contents