Install Fittings On The Autoboom Valve; Mount The Autoboom Valve - Raven AutoBoom Installation Manual

C 3
HAPTER

INSTALL FITTINGS ON THE AUTOBOOM VALVE

Before mounting the AutoBoom valve on the machine, install the proper fittings on the valve. This prepares the
valve for installation and simplifies the hose connection process later in the procedure. Refer to the following table
to install the fittings in the appropriate ports of the AutoBoom valve.

MOUNT THE AUTOBOOM VALVE

1. Secure the AutoBoom valve (P/N 063-0131-124) to the mounting plate using four 5/16"-18 hardware.
FIGURE 1. AutoBoom Valve Mounted to the Center Rack
2. Secure the mounting plate to the machine's center rack.
NOTE: Install the AutoBoom valve so ports LC and RC point down.
Install the Pressure and Tank Hoses
8
NOTICE
The appearance of the AutoBoom hydraulic valve
may vary slightly from the images contained in
this manual. However, the fittings, hose
connections, and cable connections remain the
same.
WARNING
Hydraulics are under pressure. Care should
always be taken with a system that has been
pressurized. When disconnecting or purging
hydraulic hoses, be aware that the hydraulic fluid
within the machine's system may be extremely
hot and under high pressure.
Case IH Patriot 2240/2250 AutoBoom™ Installation Manual