Chapter 3
Install Fittings on the AutoBoom Valve
Before mounting the AutoBoom valve on the machine, install the proper fittings in the valve. This prepares the
valve for installation and simplifies the hose connection process later in the procedure. Refer to the following
table to install the fittings in the appropriate ports of the AutoBoom valve.
Fitting - 9/16" JIC (M) to 9/16" SAE O-Ring (M) Straight Adapter
Fitting - 3/4" JIC (M) TO 9/16" SAE O-Ring (M) Straight Adapter
Fitting - 3/4" JIC (M) to 3/4" SAE O-Ring (M) Straight Adapter
Fitting - 3/4" JIC M/F 90° Swivel Elbow
Mount the AutoBoom Valve
AutoBoom Valve Mounted on the Valve Mounting Plate
FIGURE 7.
Secure the AutoBoom valve (P/N 063-0131-125) to the mounting plate (P/N 107-0171-619) using four
1.
5/16"-18 x 7/8" hex bolts (P/N 311-0052-104) and four 5/16" zinc lock washers (P/N 313-1000-019).
14
Fitting
Spra-Coupe 7X60 (2010 & Newer) AutoBoom® Installation Manual
Part Number
Port
333-0012-045
LC, RC, LSP
333-0012-055
LV, RV
333-0012-093
P, Right T
P, Right T
333-0012-064
LV, RV