C
3
HAPTER
INSTALL THE FITTINGS ON THE AUTOBOOM VALVE
Before mounting the AutoBoom valve on the machine, install the fittings in the appropriate ports of the
AutoBoom valve. This prepares the valve for installation and simplifies the hose connection process later in the
procedure. Refer to the following table to install the fittings.
Fitting - 11/16" ORFS (M) to 3/4" SAE O-Ring (M) 90° Elbow
Fitting - 11/16" ORFS (M) to 9/16" SAE O-Ring (M) Straight Adapter
Fitting - 13/16" ORFS (M) to 3/4" SAE O-Ring (M) Straight Adapter
Fitting - 11/16" Hex 9/16" SAE O-Ring Plug
MOUNT THE AUTOBOOM VALVE
FIGURE 1. AutoBoom Valve Mounted on the Machine
Secure the AutoBoom valve (P/N 063-0131-124) to the mounting bracket on the machine's center rack using four
5/16" hex bolts (P/N 311-0052-104) and four 5/16" lock washers (P/N 313-1000-019).
NOTE:
Mount the valve so that Ports LC and RC point down.
14Case IH Patriot 250/2240/2250 & New Holland SP2500 (80'-100' Booms) AutoBoom® Installation Manual
Fitting
Part Number
Port
LF CYL RTN,
333-0012-165
RT CYL RTN
333-0012-084
LC, RC
333-0012-168
P, T
333-0012-194
LV, RV