Chapter 3
Install Fittings on the AutoBoom Valve
Before mounting the AutoBoom valve on the machine, install the proper fittings in the valve. This prepares the
valve for installation and simplifies the hose connection process later in the procedure. Refer to the following
table to install the fittings in the appropriate ports of the AutoBoom valve.
Fitting - 13/16" ORFS (M) to 3/4" SAE O-ring (M)
Fitting - 11/16" ORFS (M) to 9/16" SAE O-ring
Fitting - 11/16" hex 9/16" SAE O-ring plug
Mount the AutoBoom Valve
AutoBoom Valve Mounted on the Valve Mounting Plate
FIGURE 7.
Secure the PowerGlide AutoBoom valve (P/N 063-0131-124) to the valve mounting plate (P/N 107-0171-
1.
619) using four 5/16" hex bolts (P/N 311-0052-104) and four 5/16" lock washers (P/N 313-1000-019).
AutoBoom Valve Mounted on the Sprayer
FIGURE 8.
Secure the mounting plate on the center rack (so that the P and T Ports face up) using two 4" W x 5" L x
2.
3/8" thread U-bolts (P/N 107-0171-606) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
12
Fitting
Miller Condor Spray-Air Boom AutoBoom Installation Manual
Part Number
333-0012-168
333-0012-084
LC, RC
333-0012-194
LV, RV
Port
P, T