Introduction; Make And Model Compatibility; Installation Overview - Raven Hawkeye 2 Installation Manual

Hide thumbs Also See for Hawkeye 2:
Table of Contents

Advertisement

CHAPTER
2

MAKE AND MODEL COMPATIBILITY

Hawkeye® 2 is a pressure-based product control system and allows for precise sprayer application over a range of
conditions and reduced spray drift. Each nozzle is controlled by an individual pulsing valve giving you a consistent
spray pattern as speed and conditions change.
Hawkeye® 2 is built on the ISOBUS communication platform which allows the system to work with most ISO
Universal Terminals (UTs) and task controllers, including the Viper® 4.
This manual is intended to provide installation instructions on the following equipment:
Compatible Equipment Information
TABLE 1.
Make and Model
Model Years 2009-2016
CNH Patriot 3330/40 and
4410/20/30/40
NOTE:
Machines must have the Aim Command Flex or Hawkeye® Product Control system to be compatible
with the cabling in this kit. If the machine does not have either of these systems installed, a Raven
CAN to ISO Product Control Upgrade kit (P/N 117-2005-005) will be required. See the kit contents in
Figure 4 on page 9. Machines with a Raven SCS 4600 console or similar with a built-in product control
node are not compatible with this Hawkeye® 2 system.

INSTALLATION OVERVIEW

The recommended process for installing the Hawkeye® 2 nozzle control system is as follows:
1. Confirm Hawkeye® 2 kit contents.
2. Replace existing strainer with an 80 mesh (or finer) strainer.
3. Remove spray tips and flush each section individually for a minimum of 20 seconds to thoroughly flush the
boom.
4. Mount Hawkeye® 2 nozzle control valves.
5. Mount the RCM - Sprayer.
6. Route and connect the inner, mid, and outer boom cables (as applicable).
7. Route and connect chassis and RCM - Sprayer cables.
8. Review the Post-Installation Notes for machine configuration tips.
Introduction: Make and Model Compatibility
I NTRODUCTION
C H A P T E R 2
Nozzle Body
Nozzle
Type
Spacing
Wilger
Boom
Width
90'
20"
100'
120'
Kit Number
117-2005-220
117-2005-221
117-2005-006
5

Advertisement

Table of Contents
loading

Table of Contents