Aai (Soft Init Command) - ICP DAS USA tM-TH8 User Manual

tM-TH8

2.22 ~AAI (Soft INIT command)

Description:
The Soft INIT command is used to enable modification of
the Baud Rate and checksum settings using software only.
Syntax:
~AAI[CHKSUM](CR)
~ Delimiter character
AA Address of the module to be set (00 to FF)
I Command to set the Soft INIT
Response:
Valid command:
Invalid command: ?AA[CHKSUM](CR)
! Delimiter character for a valid command
? Delimiter character for an invalid command
AA Address of the responding module (00 to FF)
There will be no response if the command syntax is
incorrect, there is a communication error, or there is no
module with the specified address.
Examples:
Command: ~01I
Sets the soft INIT of module 01 and returns a valid
response.
Related Commands:
Section 2.1 %AANNTTCCFF, Section 2.26 ~AATnn
74 tM-TH8 User Manual, Rev: A1.1 7MH-018-A11
!AA[CHKSUM](CR)
Response: !01