Resistance Measurement - ICP DAS USA tM-TH8 User Manual

A.6 Resistance Measurement
The tM-TH8 modules can be used for resistance
measurement. To measure the resistance, connect the
resistor using thermistor connection, as shown in Section
1.6, and set the data format to ohms. To set the data
format, send the %AANNTTCCFF command to the
module, see Section 2.1 for details, or use the DCON
utility, refer to Chapter 2 of the "Getting Started For
I-7000 Series Modules" manual that can be downloaded
from the ICP DAS website http://www.icpdas.com.
The maximum resistance that can be measured by tM-TH8
is 204800 ohms.
140 tM-TH8 User Manual, Rev: A1.1 7MH-018-A11