Table of Contents
Advertisement
4.7
Switching on the Unit
•
The red emergency stop switch (see 4, Fig. 3.1) must be in "pulled-out" (deactivated)
position. If it has been pressed in, unlock it by rotating the red part of the device either
clockwise or counterclockwise until it jumps out (Fig. 5.9).
•
Insert the key into the keylock switch located on the front panel (see 5, Fig. 3.1).
•
Rotate the key clockwise. (It is no longer possible to withdraw the key in this position.) The
system is started now. The display unit lights up.
•
The LCD shows an initial screen with the information "KLS MARTIN MCO 25 PLUS" and the
green "standby" button light will come on. An automatic self-test is performed, in the
course of which the various functions of the system are checked.
Attention! All persons present in the room must wear laser protective goggles!
Avoid direct eye contact with the red pilot laser beam!
4.8
Adjusting the LCD Contrast
Notice: If the symbols on the display unit are unclear or non-recognizable after
switching on the laser, adjust the contrast as necessary!
The LCD contrast can be adjusted in accordance with ambient conditions as follows: Operate
the "SELECT" button and hold it down, then also press the appropriate arrow key to increase
or reduce the contrast as necessary. The contrast will start changing after one second and this
process will continue until you release the buttons. You can adjust the contrast across a range
of very dark to very bright.
4.9
Basic Setting
The unit allows the user to set the laser parameters in accordance with personal preferences.
The basic choice is between "TIME MODE" and "FREQUENCY MODE". Besides, 5 different
languages are available for selection. In principle, the user can carry out this configuration
himself. However, we recommend having this done by a service technician at the time of initial
installation and startup.
4.9.1
Time Mode
When this setup is used, time values are entered for pulse parameter selection. TIME mode is
the preset mode in which the unit is delivered to the customer.
30
MCO25plus Operating Instructions
V 4.1
Advertisement
Table of Contents
