Table of Contents
Advertisement
8
Maintenance
In your correspondence with Gebrüder Martin, please specify the model you are working with
(plus the complete serial number of the laser system) when maintenance or repair issues are
involved. All these details are indicated on the rating plate of your unit. In addition, the
currently used software version is indicated below the company logo when you turn on the unit
(initial screen). If defects are detected on visual inspection, especially with regard to the mains
plug or the power cord, the unit should be withdrawn from service immediately to have it
repaired. Besides, the system should be checked and serviced at regular intervals in order to
ensure its long-term reliability.
8.1
Routine Maintenance Work
Visual Inspection &
Maintenance
Checking, disinfecting and
sterilization of the accessories
Checking the aiming beam for
coaxial exit from the handpiece
Checking CO
beam and aiming
2
beam coincidence
Checking the laser warning lamp(s)
for proper functioning
Checking the electrical connections
and cables for potential defects
Cleaning and disinfecting the unit's
surfaces
Safety check
Checking/replacing the air cooler
filter
Checking the cooling water level;
refill if required
Checking output power levels
Replacing (auxiliary) ultra-clean-air
filter
Replacing the cooling water
(0.75 l of distilled water plus
0.75 l of propylene glycol)
Table 8.1
Recommended routine maintenance & inspection schedule
74
Frequency /
Interval
prior to each
operation
daily
daily
daily
monthly
acc. to in-house
regulations
annually
annually
annually
annually
every 2 years
every 2 years
MCO25plus Operating Instructions
To Be Carried out by:
hospital staff
hospital staff
hospital staff
hospital staff
hospital staff
hospital staff
Gebrüder Martin's Technical
Service
Gebrüder Martin's Technical
Service
Gebrüder Martin's Technical
Service
Gebrüder Martin's Technical
Service
Gebrüder Martin's Technical
Service
Gebrüder Martin's Technical
Service
V 4.1
Advertisement
Table of Contents
